A) Book Ends

Royale Range - An attractive yet functional top of the range product. Complete with anti-slip grommets and a stylish perforated upstand. Two sizes are available 170mm or 220mm high, both 110mm wide.

Conventional Range - A standard simple “L” shape which come in the following sizes.
202mm high x 144mm x 135mm
227mm high x 169mm x 135mm
177mm high x 119mm x 135mm
230mm high x 230mm x 230mm

B) Indicator Block (A – Z’s)
A steel indicator block available in a range of colours to match décor. Standard sizes 190m high x 110mm deep either 50mm or 100mm wide. Lettering not supplied.

C) Booklet Display Stand
Single issue book display stand complete with an upturned support lip. (220mm high x 195mm wide).

D) Zig Zag Book Support
Display books, videos in an angled ‘zig-zag’ style – fits a 900mm shelf and is 150mm deep.

E) Library Study Carrel
Available in either a 600mm or 900mm module this carrel can either be stand alone (at the end of shelving runs) or be integrated within shelving bays.
The unit provide positions for both a P.C and slide away keyboard. Cable ducting trays are an optional extra.

F) End Décor Panels (Steel)
A variety of end décor panels can be designed and manufactured to enhance the overall ambience. Images Available.

G) Timber Canopy Brackets
These are designed to provide support when timber canopies are specified allowing fixing underneath the bracket ensuring stability. Also available for use with Periodical shelves.

H) Range Card Holders
Type A
A triangular card holder which clips into the upright post. Ideally used for aisle marking when end décor panels are not required. Should there be a requirement for décor panels an adaptor is available to allow installation onto the panels.
(150mm x 120mm x 114mm).
Type B
Mounted onto the top shelf, this item is dual sided and can be installed either along or across the canopy shelf.
(300mm x 100mm x 40mm).
Type C
A dual flat folded card holder fixed into the front of end décor panels.
(212mm x 304mm x 3mm).
Type D
A single flat folded card holder fixed into the front of end décor panels.
(212mm x 150mm x 3mm).

I) Seismic Bracing
(i) Top Ties
A dedicated bracket which locates inside the upright post allows the installation of 25mm x 25mm x 1.6mm R.H.S. providing stability from row to row.
(ii) Internal Bracing
Depending on the overall unit height, either one or two pairs of braced are required. Up to 1.875m one set above 1.875m two sets. Each set consists of threaded rod attached in the cavity created when the locking device is removed from the back brace (joiner). The threaded rod is joined by the use of turnbuckles producing a diagonal bracing system. In the case of units requiring two sets within the height, additional back brace brackets clip in and together with the back braces form the appropriate fixing medium.